Each can holder comes with a detailed, multicolor replica of the specific air munition, a regular 12 oz. can spacer, and a slim can 12 oz. spacer. The top of each 12 oz. slim can spacer will be color matched to the specific munition so that it blends in seamlessly when used. The lower half of the slim can spacer and regular 12 oz. spacer will be varied colors and are not seen when used.  

All of my products are made with PLA filaments which are known to be very stable and fairly strong when compared to other filament. I use a multi-material process which means there is no paint that could flake off or wear away. Some small portions of certain models may use TPU which is a more flexible rubber that can be used for 3D printing. 

I am always designing and testing different munition types. Some take more effort than others so the product you are requesting may be in development. Check back frequently to see what new products we have in store.

While PLA Filament is a durable filament, there are some limitations. It does have a tendency to warp or soften in high temperatures (140F or more.) Think the direct sunlight in a hot car in the summer. Therefore, it is not recommended to be stored in an area that gets this hot and exposed to direct sunlight. Through my testing with PLA, the trunk or shaded area of the car tends to be the best place if left out.

PLA can be damaged by harsh cleaners or chemicals. It is recommended that cleaning be done by wiping down warm water only and strictly when required.